Cane Evolution Tutorial

I am not a caner but after my guild's recent workshop with Carol Simmons I had leftover cane chunks to play with. My usual work is more blendy than a typical cane and I favor large patterns over small so I "blew up" my cane.

Here's how I made these...

...from these leftover 1" tall cane slices:

1) I placed a few slices of cane on a sheet of lime colored clay that was about 3 times as thick as the cane slices. Then I ran the sheet through the pasta machine on successively thinner settings (from 1 to 4-5). 

2) I alternated the direction I fed the clay through so the cane would stretch in both directions. The cane clay was more leached than the underlayer so the the cane cracked a bit as it stretched, letting the green underneath show through. 

3) I rolled a log of scrap clay, sliced it into equal portions, and rolled each piece into a ball. 

4) I ripped the cane sheet into random pieces and wrapped them randomly around the ball, covering it completely. I rolled the ball until all the wrapped pieces had melded together. I turned two of the balls into long barrel shapes.

5) With my needle tool I traced lines to loosely define shapes of leaves and petals. 

6) I baked the beads for 15 minutes and then lightly sanded with 1000 grit wet-dry sandpaper. 

7) I rubbed black liquid clay into the etched lines and wiped off the excess with a paper towel.

Then the beads went back into the oven for 15 more minutes. 

8) I sanded them again with 1000 grit. I could have stopped at this point but I like them shiny so I used my buffer.

The cane slices on the beads below were put on a lilac base layer. I didn't etch these beads. I wish I would have, the design would have looked more "focused."

So, there you go. Grab some of those old canes and blow 'em up!